MCT 5097 Corrosion Inhibitor For Potable Water System
MCT 5097 is a liquid Zinc/Ortho Phosphate product that is designed to provide corrosion protection in potable water systems. The ingredients in MCT 5097 act to inhibit corrosion by forming a protective, microscopic film on metal surfaces. This film acts as a barrier to minimize the release of iron, lead, copper, and other metals that can produces harmful effects in the system. Also, red water problems that result from corrosion is greatly reduced or eliminated.
MCT 5097 is composed of ingredients accepted by the National Sanitation Foundation (NSF) for use in potable water supplies. MCT 5097 is approved for maximum use to 29.6 mg/L in the system. Also, the raw materials are recognized as safe (GRAS) according to the provisions in the Code of Federal Register.
Directions for Use:
MCT 5097 should be fed proportional to water flow. An initial starting dosage of approximately 4-5 gallons MCT 5097 per million gallons of system water is recommended. Typical dosage residuals range from 1-4 ppm phosphate by orthophosphate test procedure. Increase or decrease dosage depending on severity of system conditions. Test kit code 3114 for orthophosphate is recommended.
Product Data:
Form
Liquid
Specific Gravity
1.41
Product pH
<1
Weight/Gallon
11.8
Phosphate/Zinc ratio
5:1
Freeze Point
3°F
Handling:
MCT 5097 is an acidic solution. DO NOT GET IN EYES, ON SKIN OR ON CLOTHING. Use with adequate ventilation. Avoid breathing vapors. In case of contact, immediately flush eyes or skin with large amounts of water for at least 20 minutes. Call a physician.
Product Storage:
Do not allow product to freeze. Keep container closed when not in use. Keep this product away from children.
Available Packaging:
5 gallon pail
59 lbs.
15 gallon drum
176 lbs.
30 gallon drum
352 lbs.
55 gallon drum
647 lbs.
If you would like more information about becoming a distributor of Midsouth Chemical's products, Contact Us!
